Correct Way To Install Rear View Camera

Looking for how to install rear view camera ? no need to look further. Rearview camera is a wonderful safety tool that is great for enhancing the safety on the road. Nowadays, almost every car comes with the backup camera. Unfortunately, if you have an older car, you will not have this technology available. This doesn’t mean you can’t take advantage of the handy technology. Installing the camera is not a challenging and difficult task. In this article, we have talked about how to install the rearview camera ?

Let’s have a look at the way to install the camera.

Step 1

The first step is to place the video monitor; you can do it by using a suction cup on the windshield. Then, you have to power the monitor using the adaptor provided with it.

Step 2

In this step, you will have to figure out the best path for the camera cable. The camera must be connected to the reverse tail lights. You will have to decide the route for linking cable of the camera from the number plate to the inside of the car.

Step 3

Next, you will have to look for the power cable. After you have found the cables, you have to determine the negative and positive wires.

Step 4

You must connect the negative and the positive wires together using the snap lock. You must attach the red wire of the camera to the positive wire. The black cable of a rearview camera to the negative wire. Once the cable is connected, it will cause the camera to turn on when the gear is shifted into the reverse position.

Step 5

The next step deals with installation of the camera. There are different ways to install the camera that depends on the type of the camera. Some of the cameras must be installed on the bumper, while some can be mounted on the license plate. If you have a camera that must be placed on the bumper, you will have to drill a hole. Mostly, the camera comes with a kit that you can use for installing the camera. You can use the hole saw from the kit for cutting the hole.

Another way to install the camera is by sliding it on the top of the plate. For this, you will have to unscrew the number plate, slide the camera on the top and secure it by firmly pressing it in the place. After that, you must reattach plate. You can alter the camera angle as per your need.

Step 6

If there is any loose wiring, you need to tidy it up with lining. Once, you have tucked the wire away, you should test your camera.

There you go; follow these simple steps and safely reverse or park your car. It is crucial for you to install the rearview camera for not only protecting your car but others around you. You have to be very careful when installing the camera.

Share this post



Leave a Reply

Your email address will not be published. Required fields are marked *